---

Manual Reference Pages  - GLUPWLCURVE (3G)

---

gluPwlCurve - describe a piecewise linear NURBS trimming curve

CONTENTS

C Specification
Parameters
Description
Notes
See Also

void gluPwlCurve( GLUnurbs* nurb,

                GLint count,
                GLfloat* data,
                GLint stride,
                GLenum type )

nurb	Specifies the NURBS object (created with  gluNewNurbsRenderer).
count	Specifies the number of points on the curve.
data	Specifies an array containing the curve points.
stride	Specifies the offset (a number of single-precision floating-point values) between points on the curve.
type	Specifies the type of curve. Must be either  GLU_MAP1_TRIM_2 or  GLU_MAP1_TRIM_3.

 gluPwlCurve describes a piecewise linear trimming curve for a NURBS surface. A piecewise linear curve consists of a list of coordinates of points in the parameter space for the NURBS surface to be trimmed. These points are connected with line segments to form a curve. If the curve is an approximation to a curve that is not piecewise linear, the points should be close enough in parameter space that the resulting path appears curved at the resolution used in the application.

If type is  GLU_MAP1_TRIM_2, then it describes a curve in two-dimensional (u and v) parameter space. If it is  GLU_MAP1_TRIM_3, then it describes a curve in two-dimensional homogeneous (u, v, and w) parameter space. See the  gluBeginTrim reference page for more information about trimming curves.

To describe a trim curve that closely follows the contours of a NURBS surface, call  gluNurbsCurve.

 gluBeginCurve(3G),  gluBeginTrim(3G),  gluNewNurbsRenderer(3G),  gluNurbsCurve(3G)

Jump to page    or go to Top of page |  Section 3G |  Main Index.